Switches/Jumper/Shunt; 8-Position Dip Switch - Multitech MMH900 User Manual

3.5

Switches/Jumper/Shunt

Switch settings can be changed by taking off the front panel. To change
the RKWL/144 jumper, V.24/V.35 shunt, V.29/V.33 shunt, or the 2834
shunt, the front panel and top cover need to be removed. The switches,
jumper and shunts are shown on the base in Figure 3-3.
1 2 3 4 5 6 7 8
8-Position
DIP Switch
3.5.1

8-Position DIP Switch

The 8-position DIP switch is shown in Figure 3-3 and the function of
each position is as follows:
Switch position 1:
Switch position 2:
Switch Position 3:
Switch Position 4:
Switch Position 5:
Chapter 3 - Front & Rear Panel Descritpions
OTHER RKWL14. 4
1 2 3 4
Composite
4-Position
Link Internal
DIP Switch
Modem Jumper
Figure 3-3. Base
Closed Initiate Downline Load Off
Open (UP) Initiate Downline Load On
(used for downline loading only)
Closed External Link Device Selected
Open (UP) Internal Link Device Selected
Closed Four Channel Operation
Open (UP) Eight Channel Operation
Closed Disable Command Modem Remote
Access
Open (UP) Enable Command Modem Remote
Access (default)
Not Used
V.24 Shunt
V.35 Shunt
V.35 V.24 V.29/V.33
V29/V33
Shunt
2834
2834 Shunt
Power
Supply
41