Multitech MMH900 User Manual page 78

$MUXSP 2400
$MUXSP 7200
$MUXSP 14400
$MUXSP 38400
$MUXSP 64000
$MUXSP 115200
$MUXB MUX BACK-TO-BACK
The Mux Back-to-Back ($MUXB) command is only
used during testing of the composite link when the
back-to-back cable is connected between two
MultiMuxes. The default value is ($MUXB0) and is
used during normal operation. In the testing mode
with the back-to-back cable connected, the
($MUXB1) command is used.
#SYNC SYNC
The Sync command configures the composite link
for Synchronous mode. When configuring the
composite link for synchronous mode and internal
clocking, the Mux Speed command sets the speed
of the composite link. If the composite link is in
synchronous mode and external clocking is used,
the Mux Speed command is not used. The default
condition for the composite link is Sync mode.
#ASYNC ASYNC
The Async command is used to set the composite
link to Asynchronous mode (#ASYNC). When the
composite link is configured for Asynchronous
mode, the Mux Speed command must be set for the
composite link speed. The Mux Clocking command
is not used in Asynchronous mode. The default
condition for the composite link is Sync mode.
#CLA Composite Link Access
The Composite Link Access command allows you to
communicate thru the command port to the
composite link. The #CLA1 command enables the
command port to communicate with the composite
link in order to reconfigure the composite link device.
Chapter 5 - Commands
$MUXSP 4800
$MUXSP 9600
$MUXSP 19200
$MUXSP 57600
$MUXSP 76800
$MUXSP 128000
78