3.6.1.3
Connecting the Centronics interface
The procedure for connecting the Centronics interface is explained below.
Step 1 :
Turn off the printer and your computer.
Step 2 :
Plug the cable connector of the interface cable into the interface connector at the back of the
printer. Squeeze the wire clips together until they lock into place.
Step 3 :
Plug the other end of the cable into the computer's port.
•
Refer to your computer's manual for the procedure to connect to your computer.
3.6.1.4
Connecting the network interface
•
Follow the instructions below when connecting the network interface cable. Otherwise,
electrical shock or fire may occur.
Do not touch the connector.
o
Do not connect the network cable connector to the interface board having different
o
specifications.
The procedure for connecting the network interface is explained below.
Step 1 :
Switch off the printer.
Step 2 :
Plug the connector of the Ethernet cable into the connector of the network interface board at the
back of the printer.
Step 3 :
Connect the other end of the Ethernet cable to the network.
Downloaded From ManualsPrinter.com Manuals
1 = Centronics interface connector
2 = Interface cable
Notes
Caution
Viper TX – Operation Instructions
42
AP-75710, Rev. 1.1, 09/01/2008