To connect the power cable, follow the steps below.
Step 1 :
Plug the power cable to the AC inlet on the back of the printer.
Step 2 :
Plug the cable correctly in the outlet.
•
If the power cable is damaged, contact one of the following :
o
o
•
If you cannot use earth terminals or find any of them, contact the shop where you bought your printer.
•
Do not unplug the power cable when the printer is on. If the power cable has been unplugged, leave
the printer for at least 1 minute before plugging the cable in again.
Downloaded From ManualsPrinter.com Manuals
1 = AC inlet
2 = Power cable
Notes
The distributor where you bought your MUTOH printer.
Your local MUTOH dealer.
Notes
Viper TX – Operation Instructions
45
AP-75710, Rev. 1.1, 09/01/2008