Calibrating The Winder System; Calibrate The Tensioning Systems - MUTOH Viper TX Operation Instructions Manual

3.5 CALIBRATING THE WINDER SYSTEM

3.5.1 Calibrate the tensioning systems

Parts and Tools :
No. Description
1 Synthetic paper strip
2 Hexagon wrench 2,5 mm
3 Hexagon wrench 3 mm
4 Hexagon wrench 4 mm
No. Description
1 Tape
2 Pencil
3.5.1.1 Checking the calibration
The procedure below describes the calibration check of the rear tensioning system. The procedure to check
the front tensioning system is the same.
P 1 : P
ART REPARING THE SYNTHETIC PAPER STRIP
Step 1 :
Put the pressure rollers in the up position.
Step 2 :
Go to the back of the machine
Step 3 :
Create a loop with the synthetic paper strip around the upper bar of the rear tension system.
Step 4 :
Check if the edges of the loop (indicated on the images below) are aligned on each other.
Downloaded From ManualsPrinter.com Manuals
Included in kit
NOT included in kit
29
Viper TX – Operation Instructions
AP-75710, Rev. 1.1, 09/01/2008
Quantity
1
1
1
1
Quantity
1
1