MUTOH Viper TX Operation Instructions Manual page 30

Step 5 :
Slide the end of the strip (1) under the pressure rollers (4) in position 1 of the printer. See image
below.
Step 6 :
Go to the FRONT SIDE of the printer.
Step 7 :
Carefully pull the strip until it is a little tensioned.
•
Don't pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
•
Make sure that you have an equal tension on the left and right of the strip.
P 2 : D
ART RAWING THE CONTROL LINES
Step 1 :
Place the adjustment plate onto the strip and slide it against the pressure rollers.
Downloaded From ManualsPrinter.com Manuals
1 = Synthetic paper strip
2 = Paper loop
3 = Tensioning bars
4 = Pressure rollers
Caution
Viper TX – Operation Instructions
30
AP-75710, Rev. 1.1, 09/01/2008