MUTOH Viper TX Operation Instructions Manual page 33

Step 2 :
Loosen (don't remove) the 4 screws on the side of the adjustable bracket. (See image below)
Tool : Hexagon wrench 4 mm
Step 3 : Use the 2 screws (1) in the tension bar bracket to adjust the tension system. Tool : Hexagon
wrench 3 mm
BEFORE line 1 (Case A on image
above)
BEHIND line 1 (Case B on image
above)
•
Make sure to turn both adjustment screws an equal amount of turns.
Step 4 :
Check the calibration again and repeat the adjustment until the lines overlap each other.
Downloaded From ManualsPrinter.com Manuals
1 = Screws
2 = Adjustable bracket
1 = Adjustment screws
IF Line 2 lays...
Important
Viper TX – Operation Instructions
THEN turn the adjustment screws as
follows :
33
AP-75710, Rev. 1.1, 09/01/2008