Connecting The Cables Of The Winding System - MUTOH Viper TX Operation Instructions Manual

3.7 CONNECTING THE CABLES OF THE WINDING SYSTEM

•
Use a power cable that is suitable to the local power specifications when connecting the UW/W
100 to the power grid.
•
If the power cable is damaged, contact :
o
o
Procedure :
Step 1 :
Connect the power cable to the power supply connector (1).
Step 2 :
Check if the all cables of the UW/W are connected to the correct connector (1 to 6). See image
below for the location of the connectors.
•
With a small intervention it is possible to reverse your winding direction.
•
Mount the Motor twist cable between the control box and the front motorized unit cable.
•
Check if the cable to the operation panel is connected properly on both sides.
Downloaded From ManualsPrinter.com Manuals
Caution
The shop where you bought the product
Your MUTOH local dealer
1 = Operation panel connector
2 = Foot switch connector
3 = Front motorized unit connector
4 = Rear motorized unit connector
5 = Power supply connector
6 = PCB Box
7 = Not used
Notes
Notes
Viper TX – Operation Instructions
46
AP-75710, Rev. 1.1, 09/01/2008