Chery A21 2005 Service Manual page 87

Chery Service Manual for A520
bolts of the front row seats seat belts and
make sure that the latch of the seat belts
could be operated easily and the tightening
torque for the fixing nuts is 50±5 N•m.
(uniform thread fastening glue should be
applied to all fasteners of this assembly
before installing) The belts could extend and
shrink easily and could not slack after the
latch is fastened with the lock striker. The
installation angle of the left/right rear seat
belt retractor assembly is 90°. The tightening
torque for all fasteners of this assembly is
50±5N•m and the fasteners should be applied
with the thread fastening glue before
installing. The belts could extend and shrink
easily and could not slack after the latch is
fastened with the lock striker. The catch bolts
of the middle seat belt should be applied with
thread fastening glue and the tightening
torque of which is 50±5N•m. The lock screw
of the double end clip ring should be applied
with thread fastening glue and the tightening
torque of which is 50±10N•m;
7. Remove the upper trim panel for B
pillar;
PDF created with pdfFactory Pro trial version
Body Dimension and Accessories
3
www.pdffactory.com
Figure 99
Figure 100
Figure 101