Chery A21 2005 Service Manual page 70

Chery Service Manual for A520
③ Pull the piano wire along the bonding
agent to cut it off.
Tip: Do not let the piano wire spoil the two
stoppers.
④ Remove the glass, and then remove the
moulding of the rear window
The installing steps are reverse to those for
removal.
INSTALLING THE GLASS OF THE
REAR WINDOW
1. Fitting the rear window moulding
Place the moulding around the glass and fit it
manually.
Tip: Be sure to remove the glass of the rear
window first before fitting the moulding
2. Clean and finish the contact surface of
the body and cut off the rough parts on
the body;
Tip: Leave bonding agent as much as
possible on the body and clean the cut
surface of the bonding agent with a rag
soaked with washer fluid.
Tip: Even if the entire bonding agent has
been cleared, you should also clean the body.
PDF created with pdfFactory Pro trial version
Body Dimension and Accessories
8
www.pdffactory.com
Stopper
Figure 168
Figure 169
Bonding
agent
Figure 170