Chery A21 2005 Service Manual page 123

CHERY A520 SERVICE MANUAL
(2) Unbolt the wheel.
Assembly process
(1) When installing the wheel and tire
assembly, you should fasten the wheel
bolts onto the wheel hub by using your
hands, and then take special tools to
fasten it tightly according to the
diagonal process, with the tightening
torque of 110±10 Nm. Impact wrench is
prohibited to use in order to prevent the
wheel from being damaged or screwed
up too loose or too tight. Lubricant
grease cannot be applied onto the wheel
bolts. (After the initial driving of
100km, the bolts of the installed wheels
and tire assembly should be fastened
once to ensure the fastening torque. The
inspection on the fastening torque of
wheel bolts is one of the daily
maintenance works).
(2) When fastening fixing nuts, you should
adopt cross method. The fasten degrees
of all fixing nuts should be similar, and
wheels can rotate freely. Finally, when
tightly fastened, the wheels should be
on the ground.
(3) Furnish with decoration cover or
deployed the decoration cover as per
requirement.
card-typed decoration cover, you should
slap by hand or use rubber tools to
knock it in.
PDF created with pdfFactory Pro trial version
When installing
42
www.pdffactory.com
CHASSIS