Chery A21 2005 Service Manual page 223

Chery Service Manual for A520
21. Take out the door handle;
A: Latch pull rod
B: Opening out push rod
C: Latch (could be replaced directly on the
vehicle)
22. Remove the door check;
Assembly
torque for the bolt is 7.2±0.7N·m and the
value is 25±3 N·m while mounted on the
door pillar and 9±1 N·m while mounted on
the door. The door check should work easily,
reliable without being hit and stuck. Grease
should be applied into the room between the
pull rod and the slider of the door check.
23. Remove the weather strip from the door
opening;
During installation, every corner should be
fitted in place and no folds are allowed. The
joint of weather strip should be placed in the
lower middle of the door opening. The
weather strip should have a proper rigidity
and should not interfere with the opening and
closing of the door after the lock and hinge
have been adjusted to the operating mode.
The hardness of the weather strip should be
proper without great variation with the
temperature changes. The surface of the
assembled rubber strip should not have any
defects such
deformation and warp etc.
PDF created with pdfFactory Pro trial version
requirements: The
as hammering
Body Dimension and Accessories
A
C
tightening
imprint,
8
www.pdffactory.com
B
Figure 65
Figure 66
Figure 67