Sleep Mode Commands; Table 91. Z Parameters - Motorola g20 Developer's Manual

AT Commands Reference
4.10.1.9 Z, Reset to Default Configuration
This command drops the current call, and resets the values to default configuration. The only acceptable value is 0.
Set Command
Command
ATZ<value>
Read Command
The Read command for Z is not defined, and therefore is not supported by the g20. The g20 returns an error.
Test Command
The Test command for Z is not defined, and therefore is not supported by the g20. The g20 returns an error.
The following table shows the Z parameters.
<Parameter>
<value> 0
Example
ATZ0
OK
4.10.2

Sleep Mode Commands

In order to improve the power consumption, the g20 supports a low-power consumption mode, called "Sleep mode". The g20
has internal decision conditions for entering and exiting sleep mode. As the terminal and the g20 operate in a combined system,
and as the communication between the g20 and the terminal must be reliable, there should be a mechanism agreed upon by both
the g20 and the terminal to co-ordinate their separate sleep mode entering and exiting sequences. The g20 will not enter sleep
mode unless the terminal enables the g20 sleep mode and signals its readiness for sleep. For this purpose, a set of AT commands
and dedicated HW lines are defined.
190
OK
or:
+CMS ERROR: <err>

Table 91. Z Parameters

Description
Default configuration
Response/Action
98-08901C68-O