Table of Contents
Advertisement
Example
at+MIPCLOSE=1
OK
at+MIPCLOSE=2
ERROR
at+mipclose?
+MIPCLOSE: 1 2
at+mipclose?
+MIPCLOSE: 0
4.15.2.4
+MIPSETS, Set Size for Automatic Push
This command causes the g20 to set a watermark in the accumulating buffer. When the watermark is reached, data is pushed
from the accumulating buffer into the protocol stack.
Data chunks between the terminal and the g20 are limited to be smaller than 170 characters. In order to reduce the overhead of
sending small amounts of data over the air, the g20 uses an accumulating buffer. The terminal can specify a watermark within
the accumulating buffer size limits to indicate how much data should be accumulated.
Set Command
Command
+MIPSETS= <Socket ID>,<Size>
Read Command
Command
+MIPSETS?
Test Command
Command
+MIPSETS=?
98-08901C68-O
//The terminal closes the opened socket
//The terminal closes the socket that wasn't opened
//Sockets 1 and 2 are opened
//No opened sockets
Response/Action
OK
or:
ERROR
+MIPSETS: <err>
Response/Action
+MIPSETS: <socket ID>,<Current Size settings>
[<socket ID>,<Current Size settings><CR><LF>
For all ACTIVE sockets.
Response/Action
+MIPSETS: (1-4),(1-1500)
AT Commands Reference
251
Advertisement
Table of Contents
