Table of Contents
Advertisement
AT Commands Reference
4.12.1.3
+CGQMIN, Quality of Service Profile (Min Acceptable)
This command enables the terminal to specify the minimum acceptable profile which is checked by the MT against the negoti-
ated profile returned in the Activate PDP Context Accept message.
Set Command
The Set command specifies a profile for the context identified by the (local) context identification parameter, <cid>. As this is
the same parameter that is used in the +CGDCONT command, the +CGQMIN command is effectively an extension of the
+CGDCONT command. The QoS profile consists of a number of parameters, each of which may be set to a separate value.
Command
AT+CGQMIN=[<cid>
[,<precedence> [,<delay>
[,<reliability.> [,<peak>
[,<mean>]]]]]]
Read Command
The Read command returns the current settings for each defined context.
Command
AT+CGQMIN?
Test Command
The Test command returns the parameter value ranges for each <PDP_type>.
Command
AT+CGQMIN=?
216
Response/Action
OK
or:
+CME ERROR: <err>
Response/Action
+CGQMIN: <cid>, <precedence>, <delay>,
<reliability>,<peak>, <mean>[<CR><LF>+CGQMIN:
<cid>, <precedence>,<delay>, <reliability.>, <peak>,
<mean>[...]]
OK
or:
+CME ERROR: <err>
Response/Action
+CGQMIN: <PDP_type>, (list of supported
<precedence>s), (list of supported <delay>s), (list of
supported <reliability>s), (list of supported <peak>s),
(list of supported <mean>s)
[<CR><LF>+CGQMIN: <PDP_type>, (list of supported
<precedence>s), (list of supported <delay>s), (list of
supported <reliability>s), (list of supported <peak>s),
(list of supported <mean>s)
OK
or:
+CME ERROR: <err>
98-08901C68-O
Advertisement
Table of Contents
