AT Commands Reference
4.3.4.2
+CLCC, List Current Calls
This command returns a list of all current g20 calls and their statuses, and also enables/disables the unsolicited indication of the
call list. (If no calls are received, no information response is sent to the terminal.)
If the command succeeds but no calls are available, no information response is sent to the terminal.
The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 in hold).
On all platforms besides Telematics-enabled GSM platforms, this command responds with a +CME error indicating that the
operation is not supported.
Set Command
The Set command enables/disables unsolicited indications.
Command
AT+CLCC=<state>
Execute Command
The Execute command enables the receiving of data about current calls.
Command
AT+CLCC
Read Command
The Read command returns the call status.
Command
AT+CLCC?
86
Response/Action
OK
or:
+CME ERROR: <err>
Response/Action
+CLCC: <idx>,<dir>,<call state>, <mode>,
<mpty>[,<number>,<type>,<alpha>]
OK
Response/Action
+CLCC: <state>
OK
or:
+CME ERROR <err>
98-08901C68-O