Table of Contents
Advertisement
Reference Tables
AT
Command
+FMI
This command requests manufacturer identification.
+FMM
This command requests the model identification.
+FMR
This command requests the revision identification.
+FRH
This command causes the DCE to receive HDLC framed data and deliver the next
received frame to the terminal.
+FRM
This command causes the DCE to enter the receive mode.
+FRS
This command causes the DCE to listen and to report back an OK result code when
the line has been silent for the specified amount of time.
+FTH
This command causes the DCE to transmit data framed in the HDLC protocol.
+FTM
This command causes the DCE to transmit data.
+FTS
This command causes the DCE to stop any
+GCAP
This command requests the overall capabilities of the g20.
+GMI
This command requests manufacturer identification.
+GMM
This command requests the model identification.
+GMR
This command requests the revision identification.
+IFC
This command is responsible for setting the local terminal-g20 flow control.
+IPR
This command is responsible for setting and saving the request baud rate.
+MAFEAT
This command controls the various algorithm features, such as sidetone, echo
cancel and noise suppress.
+MAID
This command returns the AT Feature Review that is supported in the g20.
+MAMUT
This command controls the muting/unmuting of all input paths (MIC, HDST_MIC,
DIGITAL_RX).
+MAPATH
This command sets/requests the active input accessory, and the output accessory
for each feature.
+MAPV
This command returns the version of the accessory protocol that is supported by the
g20.
+MAVOL
This command enables you to determine a volume setting for a particular feature in
a particular accessory.
310
Table 137. AT Commands (Alphabetical) (Continued)
Description
transmission)
Page
39
40
41
236
234
231
235
232
230
147
39
40
41
228
151
167
47
169
163
48
165
98-08901C68-O
Advertisement
Table of Contents
