AT
Command
Fax Class 1
Fax Commands
+FCLASS
This command places the TA into a particular mode of operation (data, fax, voice).
+FTS
This command causes the DCE to stop any
+FRS
This command causes the DCE to listen and to report back an OK result code when
the line has been silent for the specified amount of time.
+FTM
This command causes the DCE to transmit data.
+FRM
This command causes the DCE to enter the receive mode.
+FTH
This command causes the DCE to transmit data framed in the HDLC protocol.
+FRH
This command causes the DCE to receive HDLC framed data and deliver the next
received frame to the terminal.
Features
STK Commands
+MTKE
This command enables/disables the SIM ToolKit functionalities.
+MTKP
Pro-active. Unsolicited event, SIM ToolKit Pro-active event.
+MTKM
Menu. Unsolicited event, SIM ToolKit Menu event.
+MTKC
This command enables customer application outgoing calls or SMSs, CALL
CONTROL and SMS CONTROL responses to be identified, if the call control facility
is activated.
TCP/IP Commands
+MIPCALL
This command creates a wireless PPP connection with the GGSN, and returns a
valid dynamic IP for the g20.
+MIPOPEN
This command causes the g20 module to initialize a new socket and open a
connection with a remote side.
+MIPCLOSE
This command causes the g20 module to free the socket accumulating buffer and
disconnect the g20 from a remote side.
+MIPSETS
This command causes the g20 to set a watermark in the accumulating buffer. When
the watermark is reached, data is pushed from the accumulating buffer into the
protocol stack.
98-08901C68-O
Table 3. AT Commands (Continued)
Description
transmission)
Product Features
Page
229
230
231
232
234
235
236
238
239
243
246
246
248
250
251
27