Table of Contents
Advertisement
4.10.1.4
X, Result Code Selection and Call Progress Monitoring Control
This command defines the data adaptor response set, and the CONNECT result code format. It determines whether or not the
g20 transmits particular result codes to the accessory. It also controls whether the g20 verifies the presence of dial tone when it
first goes off-hook to begin dialing, and whether engaged tone (busy signal) detection is enabled.
Set Command
The Set command sets the result code and call progress monitoring control.
Command
ATX<value>
Read Command
Command
ATX?
Test Command
The Test command for X is not defined by ITU, and therefore is not supported by the g20. The g20 returns an error.
98-08901C68-O
Response/Action
OK
or:
+CMS ERROR: <err>
Response/Action
X: <current value>
AT Commands Reference
185
Advertisement
Table of Contents
