Table of Contents
Advertisement
SAFETY INSTRUCTIONS
The installer must read the safety instructions before attempting to install the equipment.
DANGER
WARNING
CAUTION
Warning, Caution
DANGER
Keep away from raise/lower shaft in
hull unit when it is moving.
Gears will cause serious injury. In case of
an emergency, press the EMERGENCY
STOP button to stop the raising or
lowering of the transducer.
Confirm that there is no person below
the transducer before raising or
lowering the transducer.
WARNING
Do not open the equipment unless
totally familiar with electrical circuits
and service manual.
High voltage exists inside the equipment,
and a residual charge remains in
capacitors several minutes after the
power is turned off. Improper handling
can result in electrical shock.
Turn off the power at the mains
switchboard before beginning the
installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
Do not install the equipment where it
may get wet from rain or water splash.
Water can cause fire or electrical shock,
or damage the equipment.
Indicates a potentially hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Prohibitive Action
Mandatory Action
WARNING
Be sure no water leaks in at the hull
unit.
Water leakage can sink the vessel. Also
confirm that the transducer will not
loosen by ship's vibration. The installer of
the equipment is solely responsible for
the proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with improper
installation.
If a steel tank is installed on a wooden
or FRP vessel, take appropriate
measures to prevent electrolytic
corrosion.
Electrolytic corrosion can damage the
hull.
Install the specified transducer tank in
accordance with the installation
instructions. If a different tank is to be
installed the shipyard is solely
responsible for its installation, and it
should be installed so the hull will not
be damaged if an object strikes the
tank.
The tank or hull may be damaged if the
tank strikes an object.
Be sure to power each unit with
proper voltage.
Connection of an improper power supply
can cause fire or damage the equipment.
i
Advertisement
Table of Contents
