Furuno FSV-85-MARK-2 Installation Manual page 47

2.5.1 Cable fabrication
10S2380 cable
Fabricate the cable referring to below and connect to CN-B101 passing through ths
cable clamp of the transceiver unit.
Anticorrosive
sheath
Use the guide pin insertion tool (Code No. 10-910-0179-0) to correctly insert guide
pins to connectors.
Connector
Guide pin
Guide pin A (large)
Guide pin B (small)
LAN cable
Fabricate the cable referring to section 2.3.3.
400 ｍｍ 400 ｍｍ
45 ｍｍ 45 ｍｍ
Shield
40 ｍｍ 40 ｍｍ
Armor
Vinyl Sheath
How to fabricate 38P connector
Guide Pin A
Position No.
How to assemble 38P connector
Tool
CN-B101
1
1
(Guide pin insertion tool, notch in head)
Insulating tape
Expose cores then wind
shield around armor.
Guide Pin A Guide Pin B
(Large) (Small)
2. WIRING
Guide Pin B
2-13