Safety Instructions - Furuno CH-250 Installation Manual

SAFETY INSTRUCTIONS

Read these safety instructions before you operate the equipment.
WARNING
CAUTION
Warning, Caution
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Only qualified personnel
should work inside the
equipment.
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or equipment damage.
Be sure no water leaks in at the
transducer installation site.
Water leakage can sink the vessel. Also
confirm that the transducer will not
loosen by ship's vibration. The installer of
the equipment is solely responsible for
the proper installation of the equipment.
FURUNO will assume no
responsibility for any damage associated
with improper installation.
Indicates a condition that can cause death or serious
injury if not avoided.
Indicates a condition that can cause minor or moderate
injury if not avoided.
Prohibitive Action
Installe the specified retraction tank
in accordance with the installation
instructions. If a different tank is to
be installed the shipyard is solely
responsible for its installation, and it
should be installed so the tank
doesn't strike an object.
The tank or hull may be damaged if the
tank strikes an object.
If a steel tank is installed on a wooden
or FRP vessel, take appropriate
measures to prevent electrolytic
corrosion.
Electrolytic corrosion can damage the hull.
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Connection of an incorrect power supply
can cause fire or equipment damage.
The voltage rating of the equipment
appears on the label above the power
connector.
i
Mandatory Action
WARNING