Furuno FSV-85-MARK-2 Installation Manual page 24

1. HOW TO INSTALL THE SYSTEM
2. Attach a ground wire (IV-1.25sq, supplied locally) to the ground terminal at the
bottom of the unit, then connect the other end of the ground wire with the ship's
ground.
*
3. Set the unit to the cutout, then secure the unit with four self-tapping screws
(φ5×20, supplied).
4. Attach four bolt hole caps (supplied).
Self-tapping screw
(Ø5×20, 4 pcs)
1-16
Ground screw*
: Use the screw that is preattached to the ground terminal.
Ground wire
Bolt hole cap
(4 pcs)