Table of Contents
Advertisement
2. WIRING
4. Connect the cables on the fan to the
connector inside the control box ex-
tension box.
5. Unfasten four screws and set the inertial measurement unit, then fasten the
screws to secure it.
6. Connect the D-SUB connector inside the control box extension box to the inertial
measurement unit.
2-22
Inertial measurement unit
Connect the fan cable to
the connector (2 locations).
Rear side: Inertial measurement unit
Set the unit to the mounting screws,
then fasten the screws.
Advertisement
Table of Contents
