Mitsubishi Electric MELSEC iQ-R Series User Manual page 237

Search
Up to 32 ONVIF supported network cameras in the same network as a camera recorder module can be searched for.
This function can be performed in the "Network Camera List" screen in the module extended parameter. (Page 107
Network camera list screen)
By using this function, an ONVIF supported network camera can be detected from an actual system configuration and
information on the network camera (IP address and TCP port number) can be applied to the "Camera Individual Settings"
screen. (Page 105 Camera individual setting)
Precautions
• This function can be used when 'stopped' is stored in 'In recording operation' (Un\G1501, Un\G1701, Un\G1901,
Un\G2101) of a camera recorder module.
• If 33 or more ONVIF supported network cameras are connected on the same network, the 33rd and later ones are not
recognized. They are recognized in order from a found one.
• A manufacturer name may be displayed including a model name in the "Network Camera List" screen.
Account authentication
An account can be authenticated to connect a camera recorder module to an ONVIF supported network camera.
For account authentication, the camera type, IP address, TCP port number, user ID, and password of a target network camera
must be specified in the module extended parameter and written to a camera recorder module. (Page 103 Module
Extended Parameters (Camera Recorder Module))
Before writing module extended parameters, a user ID and password can be checked in advance by
performing the communication test in the "Communication Test" screen in the module extended parameter.
(Page 108 Communication test screen)
However, the communication test can be performed only when 'stopped' is stored in 'In recording operation'
(Un\G1501, Un\G1701, Un\G1901, Un\G2101) of a camera recorder module.
In addition, it can be performed on a network camera for which 'disabled' is stored in 'Network camera setting
enabled/disabled' (Un\G34000, Un\G34500, Un\G35000, Un\G35500) of a camera recorder module.
(Page 282 Network camera status area (Un\G34000 to 37999))
Precautions
• Specify the values set for a network camera to be connected for the IP address, TCP port number, user ID, and password
in the module extended parameter.
• An account is authenticated when the communication with a network camera starts. If the camera type, IP address, or TCP
port number is incorrect, a network camera undetected error (error code: 1D01H) occurs. In addition, if the user ID or
password is incorrect, a network camera account authentication error (error code: 1D30H) occurs.
• Some ONVIF supported network cameras may require an account for ONVIF communication. For details, refer to the
manual for a network camera used or visit the ONVIF website (www.onvif.org/conformant-products).
7 CAMERA RECORDER MODULE (DETAILED SPECIFICATIONS)
235
7.1 Function Details
7