Video Data Receiving Target Setting - Mitsubishi Electric MELSEC iQ-R Series User Manual

3.6

Video Data Receiving Target Setting

This section shows the screen for setting a network camera from which video data is received.
Window
Click "Video Data Receiving Target Setting" in the setting item list.
Displayed items
Item
[Detailed Display]/[Simple Display] button
[Select All] button
[Deselect All] button
Module
Camera No.
Receiving Target
IP Address
Video Size [MB]
*3
Resolution
*3
Video Frame Rate [fps]
*3
Video Codec
*3*4
Video Quality
Camera Comment
Recording Buffer Setting (Video Data)
*1 Can be selected only when a network camera is enabled.
Whether it is enabled can be checked in 'Network camera setting enabled/disabled' (Un\G34000, Un\G34500, Un\G35000, Un\G35500)
of a camera recorder module. (Page 282 Network camera status area (Un\G34000 to 37999))
*2 Blank when a network camera is disabled.
Whether it is disabled can be checked in 'Network camera setting enabled/disabled' (Un\G34000, Un\G34500, Un\G35000, Un\G35500)
of a camera recorder module. (Page 282 Network camera status area (Un\G34000 to 37999))
*3 Appears only for the detailed display. (The simple display is selected by default.)
*4 Blank when enabling the simple setting mode. The video size is calculated with the video quality equivalent to middle.
*5 If the video data capacity is larger than a value assigned in the recording buffer setting (video data) in the module parameter, the video
data capacity is displayed in red. In this case, data for a set saving period may not be saved. Perform any of the operations shown in the
following:
Page 61 When the capacity of accumulated video data exceeds the buffer capacity
Description
Click this to switch between the detailed display and the simple display.
Click this to select all the checkboxes in the "Receiving Target" column.
Click this to unselect all the checkboxes in the "Receiving Target" column.
The start I/O number, module name, and slot number of a camera recorder module are displayed.
The number of a network camera set in the module extended parameter is displayed.
Select the checkbox to receive video data captured by a network camera.
The IP address set for a network camera is displayed.
The buffer capacity, which is calculated based on the network camera setting and the recording saving time,
*2
is displayed.
However, if a calculated value of the buffer capacity is a decimal number, the first decimal place is rounded
up.
The resolution set for a network camera is displayed.
The video frame rate set for a network camera is displayed.
The video codec set for a network camera is displayed.
The video quality set for a network camera is displayed.
The camera comment set for a network camera is displayed.
The video data capacity, which is calculated based on the network camera setting and the selection status in
the "Receiving Target" column, is displayed for each camera recorder module in the following format:
• Video data capacity/recording buffer setting assigned in the module parameter (video data) [MB]
*1
*2
*2
*2
*2
*2
*2
3 RECORDING SETTING
3.6 Video Data Receiving Target Setting
3
*5
141