Starting And Exiting From Cx-Simulator Menus; Starting Cx-Simulator - Omron CS Series Operator's Manual

Starting and Exiting from CX-Simulator Menus

3-3 Starting and Exiting from CX-Simulator Menus

3-3-1 Starting CX-Simulator

38
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
This section describes how to start and exit the CX-Simulator.
Use this method to start the CX-Simulator in the following cases:
Note
• When the CX-Simulator performs serial communications using a com-
puter's serial port.
• When performing communications via a FinsGateway network.
• When specifying a PLC data directory and saving or reading UM or I/O
memory data for the Ladder Engine.
The following shows the CX-Simulator's startup procedure.
3. After clicking the [Start] button on the task bar, select [program] | [Omron] |
1,2,3...
[CX-Simulator] | [CX-Simulator] as shown below. (If installed in the CX-
Simulator group.)
[Select PLC] of the CX-Simulator setup wizard will be displayed as shown
below.
Section 3-3