Omron CS Series Operator's Manual page 227

I/O Memory Allocation
Address
Words Bits
A392 A39212
A393 A39300
to
A39307
A39308
to
A39315
A39300
to
A39315
A394 A39400
to
A39407
A39408
to
39415
A395 A39511
A39512
212
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Name
Peripheral ON when a communications
Port Com- error has occurred at the periph-
munica-
eral port. (Not valid in peripheral
tions Error bus mode or NT Link mode.)
Flag
RS-232C The corresponding bit will be ON
Port PT when the RS-232C port is com-
Communi- municating with a PT in NT link
cations mode.
Flag Bits 0 to 7 correspond to units 0
to 7.
RS-232C
The corresponding bit will be ON
Port PT for the PT that has priority when
Priority the RS-232C port is communi-
Registered cating in NT link mode.
Flags Bits 0 to 7 correspond to units 0
to 7.
RS-232C Indicates (in binary) the number
Port Re- of bytes of data received when
ception the RS-232C port is in no-
Counter protocol mode.
(No-
protocol
mode)
Peripheral The corresponding bit will be ON
Port PT when the peripheral port is com-
Communi- municating with a PT in NT link
cations mode.
Flag Bits 0 to 7 correspond to units 0
to 7.
Peripheral The corresponding bit will be ON
Port PT for the PT that has priority when
Priority the peripheral port is communi-
Registered cating in NT link mode.
Flags Bits 0 to 7 correspond to units 0
to 7.
Memory ON when memory corruption is
Corruption detected when the power supply
Detected is turned ON.
Flag
DIP Switch The status of pin 6 on the DIP
Pin 6 switch on the front of the CPU
Status Flag Unit is written to this flag every
cycle.
CS/CJ-series PLC
Function
1: Error
0: No error
1: Commu-
nicating
0: Not
communi-
cating
1: Priority
registered
0: Priority
not regis-
tered
1: Commu-
nicating
0: Not
communi-
cation
1: Priority
registered
0: Priority
not regis-
tered
1: Memory
corruption
0: Normal
operation
1: Pin 6 ON
0: Pin 6
OFF
Section 9-3
CX-Simulator
Settings Function
Not used.
Same as
CS/CJ-series
PLC.
Not used.
Same as
CS/CJ-series
PLC.
Not used.
Not used.
Not used.
Same as
CS/CJ-series
PLC.
Settings
Not set in
the Pro-
gram
mode