Omron CS Series Operator's Manual page 233

I/O Memory Allocation
Address
Words Bits
A403 A40309
A404 A40400
to
A40407
A40408
to
A40415
A405 A40500
and
A40501
A406 All
218
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Name
Memory ON when automatic transfer at
Card Start- startup has been selected and an
up Transfer error occurs during automatic
Error Flag transfer. An error will occur if
there is a transfer error, the
specified file does not exist, or
the Memory Card is not installed.
(This flag will be turned OFF
when the error is cleared by
turning the power off. The error
cannot be cleared without turning
the power off.)
I/O Bus Contains the 8-bit binary slot
Error Slot number (00 to 09) where an I/O
Number Bus Error occurred.
I/O Bus Contains the 8-bit binary rack
Error Rack number (00 to 07) where an I/O
Number Bus Error occurred.
SYSMAC When a transmission error oc-
BUS Mas- curs in the SYSMAC BUS sys-
ter Flags tem, the flag for the affected
Master Unit will be turned ON.
A40500: Flag for Master Unit #0
A40501: Flag for Master Unit #1
PLC Setup When there is a setting error in
Error Loca- the PLC Setup, the location of
tion that error is written to A406 in 4-
digit hexadecimal. The location is
given as the address displayed
on a Programming Console.
The CPU Unit will continue oper-
ating and the ERR/ALM indicator
on the front of the CPU Unit will
flash.
(A406 will be cleared when the
cause of the error is eliminated.)
CS/CJ-series PLC
Function
1: Error
0: No error
1: Error
0: No error
1: Error
0: No error
1: Error
0: No error
000A to
009F
hexadeci-
mal
Section 9-3
CX-Simulator
Settings Function
Same as
CS/CJ-series
PLC.
Not used.
Not used.
Not used.
Same as
CS/CJ-series
PLC.
Settings