Omron CS Series Operator's Manual page 224

I/O Memory Allocation
Address
Words Bits
A343 A34300
to
A34302
A34306
A34307
A34308
A34309
A34310
A34311
A34313
A34314
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
Name
Memory Indicates the type of Memory
Card Type Card, if any, installed.
EM File ON when a format error occurs in
Memory the first EM bank allocated for file
Format memory.
Error Flag (The flag is turned OFF when
formatting is completed nor-
mally.)
Memory ON when the Memory Card is not
Card For- formatted or a formatting error
mat Error has occurred. (The flag is turned
Flag OFF when formatting is com-
pleted normally.)
File Trans- ON when an error occurred while
fer Error writing data to file memory. (The
Flag flag is turned OFF when PLC
operation begins or data is writ-
ten successfully.)
File Write ON when data cannot be written
Error Flag to file memory because it is write-
protected or the data exceeds
the capacity of the file memory.
(The flag is turned OFF when
PLC operation begins or data is
written successfully.)
File Read ON when data could not be read
Error from file memory because the file
was corrupted. (The flag is
turned OFF when PLC operation
begins or data is read success-
fully.)
File Missing ON when the file memory doesn't
Flag exist or the source file doesn't
exist.
(The flag is turned OFF when
PLC operation begins or data is
read successfully.)
File Mem- ON when a file memory instruc-
ory Instruc- tion is being executed.
tion Flag
Accessing ON while file data is being ac-
File Data cessed.
Flag
CS/CJ-series PLC
Function
0: None
4: Flash
ROM
1: Format
error
0: No for-
mat
error
1: Format
error
0: No for-
mat error
1: Error
0: No error
1: Write not
possible
0: Normal
condition
1: Read not
possible
0: Normal
condition
1: Specified
file missing
0: Normal
condition
1: Instruc-
tion being
executed.
0: Instruc-
tion not
being exe-
cuted.
1: File be-
ing ac-
cessed
0: File not
being ac-
cessed
Section 9-3
CX-Simulator
Settings Function
Set as Memory
Card is always
installed.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Not used.
Same as
CS/CJ-series
PLC.
Not used.
Not used.
Not used.
Settings
4:Flash
ROM
209