IBM 2145-8F4 Installation Manual page 23

v Rear panel configuration label
Note: This label is installed on the cover of the power supply of the SAN
Volume Controller.
COM
1 3
2
SURGE SUPPRESSOR GROUND SCREW:
1
Remove to comply with national deviations:
UK DE SE.
Assembled in Mexico
v Do not discard the UPS or the UPS batteries in the trash label
Notes:
– The UPS can contain sealed, lead-acid batteries, which must be recycled.
– If you have a 2145 UPS unit that is already installed, you might not have this
label affixed to the outside of the UPS due to changing labeling requirements.
INPUT
INLET
LOAD
GROUP 1
16A MAX
2 REPO CONNECTOR: A 3
EXTENDED BATTERY CONNECTOR:
DO NOT DISCONNECT UNDER LOAD.
Use Class 2 Input Only
Utilisez Uniquement Une NE PAS DEBRANCER SOUS CHARGE.
Alimentation De Classe 2
This product is covered by one or more of the following U.S. Pat. Nos.
5177676, 6314007, 6330176, 6391489 & 6483730
BREAKER
1
BREAKER
2
BREAKER
3
xxi
About this guide