IBM 2145-8F4 Installation Manual page 116

4. Press the right or left buttons to move to the number field that you want to
5. Repeat steps 3 on page 85 and 4 for each number field that you want to
6. Press the select button to complete the change.
Press the right button to display the next secondary option or the left button to
display the previous options.
Subnet Mask
This option lets you display or change the subnet mask.
Attention: If you change the subnet mask address, ensure that you type the
correct address. Otherwise, you cannot access the cluster using the command line
tools or a Web browser.
Perform the following steps to change the subnet mask:
1. Press the select button. The first subnet mask number is displayed.
2. Press the up button if you want to increase the value that is displayed; press
3. Press the right or left buttons to move to the number field that you want to
4. Repeat steps 2 and 3 for each number field that you want to update.
5. Press the select button to complete the change.
Gateway
Attention:
address. Otherwise, you cannot access the cluster from the Web interface or from a
command line.
Perform the following steps to change the gateway address:
1. Press the select button. The first gateway address number field is highlighted.
86
IBM System Storage SAN Volume Controller: Installation Guide
Note: If you want to disable the fast increase/decrease function, press and hold
the down button, press and release the select button, then release the
down button. The disabling of fast increase/decrease lasts until cluster
creation is completed or until the feature is re-enabled. While disabled, if
the up or down buttons are pressed and held, the value will increase or
decrease once every two seconds. To re-enable fast increase/decrease,
press and hold the up button, press and release the select button, then
release the up button.
update.
update.
the down button if you want to decrease that value. If you want to quickly
increase or decrease the value, hold the up or down button, respectively.
Note: If you want to disable the fast increase/decrease function, press and hold
the down button, press and release the select button, then release the
down button. The disabling of fast increase/decrease lasts until cluster
creation is completed or until the feature is re-enabled. While disabled, if
the up or down buttons are pressed and held, the value will increase or
decrease once every two seconds. To re-enable fast increase/decrease,
press and hold the up button, press and release the select button, then
release the up button.
update.
If you change the gateway address, ensure that you type the correct