Paper Winds Around The Roller Of The Fuser Unit; The Paper Winds Around The Belt Unit; Corners Of The Paper Are Folded (The Edge Is Folded); 380:Paper Jam" Occurs When No Paper Is Loaded - Oki PRO330S User Manual

Paper winds around the roller of the fuser unit

Possible causes
The media weight is set
incorrectly.
Thin paper is used.
There is near-solid filling at
the front edge of paper.

The paper winds around the belt unit

Possible causes
Thin or soft paper is used.

Corners of the paper are folded (the edge is folded)

Possible causes
The paper is curled.

"380:PAPER JAM" occurs when no paper is loaded

Possible causes
When performing sensor
calibration, the paper sensor
may be misaligned and an
incorrect value may
have been detected.
Solution
Set an appropriate value for
[Media Weight] in the user-
defined paper settings of the
printer driver.
If you do not use the printer
driver, click [MENUS] - [FEEDER
CONFIG] - [MEDIAWEIGHT] on
the operator panel, and set an
appropriate value.
Use thicker paper.
Try leaving a margin at the front
edge of paper.
Solution
Use thicker paper.
Solution
The paper is curled. Use the
paper stored at appropriate
temperature and humidity.
Solution
From the operator panel,
execute [BOOT MENU] -
[SENSOR RESET].
- 212 -
Reference
Setting paper information
from the operator panel
Registering paper
information in the printer
driver
Paper specifications
-
Reference
-
Reference
Loading paper
Reference
BOOT MENU
Adjusting the paper
sensor (Sensor
calibration)