Adjusting The Volume; Setting The Volume - Oki PRO330S User Manual

Adjusting the volume

A buzzer will notify you when an error occurs to the machine or when printing is completed.
By default, the buzzer will sound when the machine has run out of paper.
This section describes how to change the buzzer volume and set whether or not to sound the
buzzer.

Setting the volume

Possible values are HIGH, LOW, and OFF.
The factory default setting is LOW.
1
Check that "READY TO PRINT" appears on the display.
2
Press « ∧ » or « ∨ » several times to display [ADMIN SETUP].
3
Press «OK».
4
Input the password when [ENTER PASSWORD] is displayed.
• The default password is "999999".
5
After you have input the password, press «OK».
6
Press « ∧ » or « ∨ » several times to display [BUZZER SETUP].
7
Press «OK».
8
When [ERROR VOLUME] is displayed, press «OK».
9
When the setting value flashes, press « ∧ » or « ∨ » to display your
desired value, and then press «OK».
10
Check that "*" is displayed to the right of the value which you want set.
11
If you press «ONLINE», the machine returns to the standby state "READY
TO PRINT".
- 54 -