Advertisement
SUBJECT: Original side to side registration
2. Adjustment
-- Preparation (making a test sheet) --
1. Fold an A4 (8
crease from the edge of the sheet.
-- Confirmation --
1. Put the test sheet directly on the exposure glass and make a copy (platen mode).
2. Check to see if the copier side to side registration is adjusted properly.
3. Feed the original in the RDH so that the edge with the line faces away from the original
feed rollers.
4. Compare the copy with the test sheet.
[A]
2.5 cm
Test sheet
Case 1:
Cases 2 and 3: The copy image has moved. Follow the procedure below.
5. Open the document feeder.
6. Remove the transport belt unit [B] (4
screws) as in figure 8.
Technical Bulletin
x 11) sheet exactly in half. Then draw a 2.5 cm (1 inch) line [A] on the
1/2
RDH case 1
Both are identical. Reassemble the copier. No further steps are
needed.
RDH case 2
[B]
Fig. 8
No. RTB-011
DATE: 15 Aug. '91
PAGE: 4 of 5
RDH case 3
Advertisement
