Advertisement
SUBJECT: Improper Stapling
PREPARED BY: M. Ninomiya
CHECKED BY:
CLASSIFICATION:
Action Required
Troubleshooting
Retrofit Information
1. Phenomenon
A) Incomplete stapling: The staples are not flush with the paper surface.
2 to 30 sheets of paper
Flat Stapling
(Normal)
B) No stapling: No staples are dispensed from the stapler.
2. Cause
A) If a staple [A] jams inside the staple bending gate [B], the gate cannot close
completely. Staples are not crimped completely, and there is about a 1mm gap
between the staple and the paper surface.
Technical Bulletin
Revision of service manual
Information only
Other
Incomplete stapling
(Loose)
[B]
FROM: Copier Technical Support Sec.
MODEL: F40 Finisher
1mm gap
[A]
No. RTB-007
DATE: Mar. 31,'91
PAGE: 1 of 3
Advertisement
