Advertisement
SUBJECT: BY PASS PAPER FEED SIDE REGISTRATION
ADJUSTMENT
PREPARED BY: M. Ninomiya
CHECKED BY:
CLASSIFICATION:
Action Required
Troubleshooting
Retrofit Information
[A]
2.5 cm
Specification
Side registration: 0 ± 2.0 mm
Preparation (Making a test sheet)
1. Fold an A4 (8 1/2 x 11) sheet exactly in half. Then draw a 2.5 cm (1 inch) line [A] on the
crease from an edge of the sheet.
Confirmation
1. Make a copy of the test chart in platen mode from the by-pass paper feed table.
2. Fold the copy once with the fold running down the middle of the copy, then verify that
the vertical line at the top center of the test chart is on the fold or within 2.0 mm of the
fold.
3. If the side registration of the by-pass paper feed table is not within the specifications, do
the following procedure.
REVISED ON MAY 15
Technical Bulletin
Revision of service manual
Information only
Other
FROM: Copier Technical Support Sec.
MODEL: F-40
No. RTB-004
DATE: Feb. 15, 91
PAGE: 1 of 2
[B]
Advertisement
