Garmin G1000 Pilot's Manual page 198

GPS NAVIGATION
Loading an approach procedure using the Active Flight Plan Page Menu:
1) From the Active Flight Plan Page, press the MENU Key.
2) Highlight 'Load Approach'
3) Press the ENT Key. The APPROACH window is displayed on the 'PROC – APPROACH LOADING' Page.
4) Select an approach and press the ENT Key. The TRANSITION window is displayed.
5) Select a transition (the 'VECTORS' option assumes vectors will be received to the final course segment of the
approach and will provide navigation guidance relative to the final approach course).
6) Press the ENT Key.
7) Highlight 'LOAD?' or 'ACTIVATE?'. 'LOAD' adds the approach to the flight plan without immediately using the
approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared for
the approach, but keeps the approach available for quick activation when needed. 'Activate' adds the approach
to the flight plan and begins navigating the approach course.
8) If the approach is not approved for GPS, a 'NOT APPROVED FOR GPS' messages is displayed with 'YES'
highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select 'NO' and press the
ENT Key.
L A
OAD RRIVAL
A published standard terminal arrival route (STAR) for the destination airport can be loaded into the
flight plan using one of three methods:
• LD STAR Softkey
• PROC Key
• Active Flight Plan Page Options Menu
The loaded arrival replaces the current arrival with the new selection.
5-82
Figure 5-69 'Not Approved for GPS' Message
Garmin G1000 Pilot's Guide for the Quest Kodiak 100 190-00590-00 Rev. C