Entering A Transponder Code - Garmin G1000 Pilot's Manual

REPLY STATUS
When the transponder sends replies to interrogations, a white 'R' indication appears momentarily in the
reply status field of the Transponder Data Box.

ENTERING A TRANSPONDER CODE

Entering a transponder code with softkeys:
1) Press the XPDR Softkey to display the Transponder Mode Selection Softkeys.
2) Press the CODE Softkey to display the Transponder Code Selection Softkeys, for digit entry.
3) Press the digit softkeys to enter the code in the code field. When entering the code, the next softkey in sequence
must be pressed within 10 seconds, or the entry is cancelled and restored to the previous code. Pressing the
BKSP Softkey moves the code selection cursor to the previous digit. Five seconds after the fourth digit has been
entered, the transponder code becomes active.
190-00590-00 Rev. C
Figure 4-34 Reply Indication
Figure 4-35 Entering a Code
Garmin G1000 Pilot's Guide for the Quest Kodiak 100
AUDIO PANEL AND CNS
Reply to
Interrogation
Entering
a Code
4-27