Fujitsu PRIMERGY TX200 S2 User Manual page 286

Chapter 9 Operation and Maintenance
■ Setting a Password
The password is set in the BIOS Setup Utility. For details on the BIOS Setup Utility, refer to "8.2.11
Security Menu" ( Pg.245).
1
Start the BIOS Setup Utility.
"8.2.1 Starting and Exiting the BIOS Setup Utility" (Pg.231)
2
Select the [Security] menu and select the type of password to set.
• For the administrator password, move the cursor to [Set Setup Password] and press the [Enter]
key.
• For the user password, move the cursor to [Set System Password] and press the [Enter] key.
3
When the password input window is displayed, enter the password to set.
Set Setup(System) Password:
Enter New Password
Confirm New Password
4
Press the [Enter] key.
This sets the password.
●
Changing/Deleting Passwords
If a password is already set, perform the above password setting operations to display the password
change window.
• To change the password, perform the following settings and press the [Enter] key.
Set Setup(System) Password:
Enter Current Password
Enter New Password
Confirm New Password
• To delete the password, enter the current password, and then press the [Enter] key without entering
anything in the second and third fields. The status of [Setup (System) Password] changes to [Not
installed].
The system shuts down after three invalid password entries. If this happens, turn off the server, turn it
back on, and then enter the correct password.
If you forgot your password and cannot start the server, change the switch block setting on the
baseboard to reset the passwords. For switch block settings, refer to "8.1 Switch Settings" ( Pg.230).
286
Enter the password
[ ]
Enter the password again for confirmation
[ ]
Enter the current password
[ ]
Enter the new password
[ ]
Enter the new password again for confirmation
[ ]