Installing Windows 2000 Server - Fujitsu PRIMERGY TX200 S2 User Manual

Hide thumbs Also See for PRIMERGY TX200 S2:
Table of Contents

Advertisement

Chapter 4 Manual OS Installation
10
Installing high reliability tools.
To ensure stable server operation, refer to "Chapter 6 High Reliability Tool" ( pg.167) and
install high reliability tools. When a RAID card is used, RAID Management Tool (Global Array
Manager) also install at the same time. When manually installing RAID Management Tool, refer
to "6.1.1 Installing RAID Management Tool (Global Array Manager)" ( pg.168).
The installation of Windows Server 2003 has completed.
Before Starting Operation
After OS installation, refer to "Chapter 6 High Reliability Tool" ( pg.167) and perform the necessary
procedures.

4.2.2 Installing Windows 2000 Server

1
Create driver disks.
Prepare necessary drivers before installing Windows 2000 Server.
Some drivers used with Windows 2000 Server are created from the ServerStart CD-ROM. For
how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.114).
2
Insert the Windows 2000 Server CD-ROM.
Turn on the server and insert the Windows 2000 Server CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Press any key to boot from CD....
Pressing any key while this message is displayed boots the system from the CD-ROM.
3
The [Windows 2000 Server Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party SCSI or RAID
driver ...
4
Install the drivers manually.
1. When the following message appears, press the [S] key.
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows 2000,
including those for which you have a device
support disk from a mass storage device
manufacturer, press S.
122
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.

Advertisement

Table of Contents
loading

Table of Contents