Fujitsu PRIMERGY TX200 S2 User Manual page 191

■ Notes When Installing Memory
The memory used in this server is composed of a pair of DIMM. Make sure to install a pair of DIMMs,
each having the same capacity.
●
Identifying Memory Modules
Check that the number beginning with "CA" (e.g., CA05946-E101) printed on the label is same on the
two DIMMs. Be sure to use a pair of modules with the same number. If the DIMMs have identification
labels, be sure to install a pair of DIMMs with the same capacity with the label placed on the same
location.
• Identification label location
Identification label A
1
• Identification label patterns
When a memory module is viewed so that the corner circled in the above figure comes to the lower
left, identification labels are applied in any of the following patterns.
Pattern
1
2
3
4
5
6
7
8
Identification label B
table: Identification Label Patterns
Label A Label B
Not applied Not applied
Applied Not applied
Applied Applied
Not applied Not applied
Applied Applied
Applied Not applied
Not applied Applied
Applied Applied
PRIMERGY TX200 S2 User's Guide
Identification label C
Label C
Not applied
Not applied
Not applied
Applied
Not applied
Applied
Applied
Applied
7
191