Fujitsu PRIMERGY TX200 S2 User Manual page 201

●
Connecting the Server Control Cable and Internal Power Cable
When installing the remote service board, the server control cable and internal power cable need to be
connected.
Connect the cables that came with the remote service board as shown in the figure below: the server
control cable and internal power cable connected to the ports on the remote service board and the ports
on the baseboard respectively. Then install the remote service board in PCI Slot 5.
[Remote service board]
[Baseboard]
After attaching the side cover of the server, connect the following cables. For how to connect cables,
refer to "PRIMERGY ServerBooks" supplied with the server, and "Supplement" supplied with options.
• USB cable
• VGA branch cable
• LAN cable
• AC adapter
PRIMERGY TX200 S2 User's Guide
Internal power connector
(5 pins)
Server control connector
(4 pins)
Internal power
Server control
connector
connector
(5 pins)
(4 pins)
Internal power cable
Server control
cable
201
7