Subaru Ascent 2023 Manual page 40

36
Seats
control switch.
Register the seat position with button "1" or
"2" or each of the key fobs.
The following memory positions can be
registered.
. Forward/backward position of the seat
. Angle of the seatback
. Angle of the seat cushion
. Height of the seat
. Angle of the outside mirrors
. Angle of the outside mirror angle on the
passenger's side when the reverse tilt-
down operates.
NOTE
The seat position can also be retrieved
with the Driver Monitoring System user
information. To do so, perform user
registration in the Driver Monitoring
System settings. Refer to "Driver Mon-
itoring System" �P222.
! Registration of memory position
with button "1" or "2"
1. Adjust the seat and outside mirror
positions under the following condi-
tions.
. The parking brake is applied.
. The ignition switch is in the "ON"
position.
. The select lever is in the "P" position.
2. Register the adjusted positions by
either of the following procedures.
. Press the "SET" button, then press
either "1" or "2" until a chirp sounds
within 5 seconds.
. While pressing and holding the
"SET" button, press either "1" or "2"
until a chirp sounds within 5 sec-
onds.
A chirp will sound once, and the seat
position and outside mirror angle on the
passenger's side will be registered.
NOTE
If a new position is registered for the
same button, the previously registered
memory position is deleted.
! Registration of the reverse tilt-
down mirror angle with button
"1" or "2"
CAUTION
Depress the brake pedal when re-
gistering the reverse tilt-down mir-
ror angle.
1. Move the select lever to the "R"
position, then the outside mirror angle
on the passenger's side will move to
the reverse tilt-down position.
2. Adjust the outside mirror angle on the
passenger's side. For details about the
settings, refer to "Remote control mir-
ror switch" �P270.
3. Move the select lever to the "P"
position, then the outside mirror angle
will return to its original position.
4. Register the adjusted positions by
either of the following procedures.
. Press the "SET" button, then press
either "1" or "2" until a chirp sounds
within 5 seconds.
. While pressing and holding the
"SET" button, press either "1" or "2"
until a chirp sounds within 5 sec-
onds.