Head Restraints - Subaru Ascent 2023 Manual

& Head restraints
WARNING
Do not change the head restraint to
the head restraint from a different
seat. The head restraints were each
designed specifically for the front
seat, second-row seat, and third-row
seat.
NOTE
It is possible to adjust the angle of the
front seat head restraints only. When
installing the front seat head restraints,
make sure that the angle of the head
restraints can be adjusted.
! Front seats
Both the driver's seat and the front
passenger's seat are equipped with head
restraints. Both head restraints are adjus-
table in the following ways.
! Height adjustment
1 Head restraint
2 Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while press-
ing the release button on the top of the
seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks. Press and hold
the release button to lower the head
restraint.
Each head restraint should be adjusted so
that the center of the head restraint is
closest to the top of the occupant's ears.
NOTE
When the head restraint cannot be
pulled out or installed due to insuffi-
cient clearance between the head re-
straint and the roof, tilt the seat and
then perform the installation and re-
moval tasks.
– CONTINUED –
47
Seats