Table of Contents
Advertisement
156
Rear gate
center information display. For details,
refer to "Car settings" �P215.
The ON/OFF setting of the audible signal
also works as the audible signal settings
for the "remote keyless entry system" and
the "keyless access with push-button start
system". However, for the warning chime
such as that caused by "Reverse function"
�P154 or "Rear gate auto closure func-
tion" �P155, it cannot be set as non-
operational.
! Initialization of power rear gate
If the power rear gate detects some
abnormality while operating, an electronic
chirp will sound and the power rear gate
operation will be automatically stopped in
either opening or closing position. In this
case, the system needs to be initialized in
the following order to restart the function
properly.
! If the power rear gate is closed
1. Keep pressing the rear gate opener
switch until it unlocked (for approxi-
mately 5 seconds) and lift up the rear
gate.
2. Pull down the rear gate until it starts to
close automatically. The system will be
initialized once the gate is fully closed.
3. Operate the power rear gate and check
that the function operates properly.
! If the power rear gate is opened
1. Pull down the rear gate until it starts to
close automatically. The system will be
initialized once the gate is fully closed.
If the rear gate will not close comple-
tely, keep pressing the rear gate open-
er button for approximately 5 seconds
and pull down the rear gate.
2. Operate the power rear gate and check
that the function operates properly.
CAUTION
If the power rear gate function does
not operate properly, have your
vehicle checked by SUBARU dealer.
Advertisement
Chapters
Table of Contents
