Locking The Doors; Unlocking The Doors; Unlocking The Rear Gate; Selecting Hazard Warning Flasher Operation - Subaru Ascent 2023 Manual

dealer for details.
& Locking the doors
Press the lock/arm button to lock all doors,
the rear gate and fuel filler lid. An electro-
nic chirp will sound once and the hazard
warning flashers will flash once.
If any of the doors (or the rear gate) are not
fully closed, the following will occur to alert
you that the doors (or the rear gate) are not
properly closed.
. An electronic chirp sounds five times.
. The hazard warning flashers flash five
times.
When you close the door, it will automati-
cally lock and then the following will occur.
. An electronic chirp sounds once.
. The hazard warning flashers flash
once.
& Unlocking the doors
Press the unlock/disarm button to unlock
the driver's door and the fuel filler lid. An
electronic chirp will sound twice and the
hazard warning flashers will flash twice. To
unlock all doors, the rear gate, briefly press
the unlock/disarm button a second time
within 5 seconds.
NOTE
If the interval between the first and
second presses of the unlock/disarm
button (for unlocking of all of the doors
and the rear gate) is extremely short,
the system may not respond.
& Unlocking the rear gate
Press the rear gate unlock button to unlock
the rear gate.
An electronic chirp will sound twice and the
hazard warning flashers will flash twice.
& Selecting hazard warning
flasher operation
Using the hazard warning flasher, the
system will give you a visible signal when
the doors are locked or unlocked. If
desired, you can turn the hazard warning
flashers off by operating the center infor-
mation display. For details, refer to "Car
settings" �P215. The setting can also be
changed by a SUBARU dealer. Consult
your SUBARU dealer for details.
& Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
Remote keyless entry system
lock/arm button three times in a 5-second
period will cause your vehicle's horn to
sound once and its hazard warning
flashers to flash three times.
NOTE
If the interval between presses is too
short when you press the lock/arm
button three times, the system may
not respond to the signals from the
remote transmitter.
& Sounding a panic alarm
To activate the alarm, press the "PANIC"
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. Unless a
button on the remote transmitter is
pressed, the alarm will be deactivated
after approximately 30 seconds.
& Setting audible signal opera-
tion
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock.
– CONTINUED –
135