Table of Contents
Advertisement
168
Hazard warning flasher
! Battery drainage prevention func-
tion
When the push-button ignition switch is left
in the "ACC" or "ON" position for approxi-
mately 1 hour, the push-button ignition
switch will be automatically switched to
"OFF" to prevent the battery from going
dead.
& When access key fob does
not operate properly
Refer to "Access key fob – if access key
fob does not operate properly" �P464.
3-3. Hazard warning flasher
The hazard warning flasher is used to warn
other drivers when you have to park your
vehicle under emergency conditions. The
hazard warning flasher works regardless
of the position of the ignition switch.
To turn on the hazard warning flasher,
push the hazard warning flasher switch on
the instrument panel. All the turn signal
lights and the turn signal indicator lights
will flash. To turn off the flasher, push the
switch again.
NOTE
When the hazard warning flasher is on,
the turn signals do not work.
3-4. Meters and gauges
NOTE
Some of the meters and gauges on the
combination meter use liquid-crystal
displays. You will find their indications
hard to see if you wear polarized
glasses.
& Speedometer
The speedometer shows the vehicle
speed.
& Tachometer
The tachometer shows the engine speed
in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrev-
ving. The engine will resume run-
ning normally after the engine speed
is reduced below the red zone.
Advertisement
Chapters
Table of Contents
