Alarm System Setting; If You Have Accidentally Triggered The Alarm System; Valet Mode - Subaru Ascent 2023 Manual

144
Alarm system
! Emergency disarming
For models with "keyless access with the
push-button start system":
If you cannot disarm the system using the
access key fob (i.e., the access key fob
broken or the access key fob battery is too
weak), refer to "Switching power status"
�P465.
For models without "keyless access with
the push-button start system":
The system can be disarmed if you turn the
ignition switch from the "LOCK"/"OFF"
position to the "ON" position with a
registered key.
NOTE
If the access key fob or transmitter
battery is too weak, replace the battery
immediately. Refer to "Replacing bat-
tery of access key fob" �P517.
& Alarm system setting
To change the setting of your vehicle's
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" �P143.
2. Sit in the driver's seat and shut all
doors, the rear gate and engine hood.
3. Turn the ignition switch to the "ON"
position.
4. Hold down " " of the driver's power
door locking switch, open the driver's
door within the following 1 second, and
wait 10 seconds without releasing the
switch. The setting will then be chan-
ged as follows.
Setting Combination
status meter display
Activate AL ON
Deactivate AL OFF
NOTE
You may have the above setting change
done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
! To stop the alarm
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the "ON"
position (models without "keyless ac-
cess with push-button start system").
. Turn the push-button ignition to the
"ACC" position (models with "keyless
access with push-button start system").
NOTE
Only registered keys will stop the
alarm. If the key is not registered, the
alarm will not stop.
& Valet mode
When you choose the valet mode, the
Horn
alarm system does not operate. In valet
Once
mode, the remote transmitter is used only
for locking and unlocking the doors and
Twice
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle's alarm system to
deactivation mode. Refer to "Alarm system
setting" �P144. The security indicator
light will continue to flash once every 3
seconds, indicating that the system is in
the valet mode.
To exit valet mode, change the setting of
your vehicle's alarm system to activation
mode. Refer to "Alarm system setting"
�P144.