Alarm System Setting; If You Have Accidentally Triggered The Alarm System; Valet Mode - Subaru Crosstrek 2020 Manual

ignition switch from the "LOCK"/"OFF" to
the "ON" position with a registered key/
access key fob.
NOTE
For models with "keyless access with
push-button start system", if the ac-
cess key fob battery is discharged,
perform the procedure described in
"Switching power status" F9-18. In
such a case, replace the battery im-
mediately. Refer to "Replacing battery
of access key fob" F11-46.
& Alarm system setting
To change the setting of your vehicle's
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
"Disarming the system" F2-26.
2. Sit in the driver's seat and shut all
doors, rear gate and engine hood.
3. Turn the ignition switch to the "ON"
position.
4. Hold down " " of the driver's power
door locking switch, open the driver's door
within the following 1 second, and wait 10
seconds without releasing the switch. The
setting will then be changed as follows.
. Type A combination meter
Setting Combination
status meter display
Activate ALon
Deactivate ALoF
. Type B combination meter
Setting Combination
status meter display
Activate AL ON
Deactivate AL OFF
NOTE
You may have the above setting change
done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
! To stop the alarm
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the "ON"
position (models without "keyless access
with push-button start system").
. Turn the push-button ignition to the
"ACC" position (models with "keyless
access with push-button start system").
Keys and doors/Alarm system
NOTE
Only registered keys will stop the
Horn
alarm. If the immobilizer transponder
is not registered, the alarm will not
Once
stop.
Twice
& Valet mode
When you choose the valet mode, the
Horn
alarm system does not operate. In valet
mode, the remote transmitter is used only
Once
for locking and unlocking the doors and
Twice
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle's alarm system for
deactivation mode. Refer to "Alarm system
setting" F2-27. The security indicator light
will continue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle's alarm system for activation
mode. Refer to "Alarm system setting" F2-
27.
2-27